Hey guys,
After struggling for months with the toner transfer method and a clothes iron I did a little research and came across
THIS TUTORIAL. I was impressed with the outcome so I purchased a GBC laminator. Not the specific model shown in the tutorial but one of
THIS MODELI have quickly been able to achieve comparable results to the tutorial and it's much easier to push the thing through the laminator than it is to fight the iron. The only downside that I see so far is that the copper clad that I have is a little thick for the laminator and I have to "persuade" it to go through with a firm steady push.
After three tries, I have an almost perfect board. I still have two very small spots to touch up with a pen, but I believe given a little time and practice even that will go away. I have much better clarity and precision than I am used to! I am ecstatic about the outcome because I have been fighting moderate results for too long.
Hope this helps someone,
Jman
